50kN Tensile Strength Test Machine Electric Vehicle Testing
Equipment
Equipment Overview
This computer-controlled testing machine is extensively applied for
evaluating the mechanical properties of a wide range of
non-metallic and metallic materials, including rubber, plastics,
cables, textiles, waterproof fabrics, nonwovens, metal wires,
foils, sheets, and rods.
With the support of various specialized grips, it is ideal for
performing tensile, compression, peel, shear, tear, and bending
(folding) tests on both raw materials and finished products.
The system features high testing accuracy, intuitive operation, and
supports multi-data output with graphic comparisons, making data
interpretation more efficient and professional.
Thanks to its modular design, the machine offers a wide selection
of interchangeable accessories, allowing users to tailor
configurations flexibly to match different testing needs.
Whether in quality control, R&D, or material certification,
this versatile and reliable testing solution is an essential tool
for enhancing testing efficiency and product development speed.
The use of servo drive can better ensure accuracy
1. Accuracy: closed-loop control of position, speed and torque is
realized; The problem of stepping motor out of step is overcome.
2. Speed: high speed performance is good, generally rated speed can
reach 2000 ~ 3000 RPM;
3. Adaptability: strong anti-overload ability, can withstand three
times the rated torque of the load, especially suitable for
instantaneous load fluctuations and requirements for fast starting
occasions;
4. Stable: low speed operation is stable, low speed operation will
not produce a stepping phenomenon similar to the stepper motor.
Suitable for occasions with high-speed response requirements;
5. Timeliness: the dynamic corresponding time of motor acceleration
and deceleration is short, generally within tens of milliseconds;
6. Comfort: heat and noise are significantly reduced.
Technical Parameters
| Test Force Range | 0-5000kg (0~50kN) |
| Displacement switch | mm, cm, in |
| Displacement measurement displays accuracy | 0.01mm |
| Deformation measuring device | 0.2%—100%FS |
| Test effective width | 400mm |
| Test stroke | 800mm |
| Working power supply | 220V/50HZ |
| Power | 1.0KW |
| Machine size | about 800×500×1500mm |
| Machine weight | about 200KG |
| Load analysis | 1/250000 |
| Load accuracy | ±0.5% |
| Safety device | overload emergency stop device, up and down travel limit device,
automatic breakpoint stop function |
| Fixture | One set each of pneumatic, winding, and wedge-type fixtures,
customized according to the customer’s product specifications. |
| Operation mode | Computer control, hierarchical mode of operation coupled with
detailed help documents and tips make it the most easy-to-use
software in the testing machine industry |
Machine weight | about 600KG |
Compression fixture | Width has to be 2 in wide or 50 mm wide flat, horizontal steel
plates whose jaws close at the rate of 0.50 +/- 0.05 in/min or 10.0
+/-1 mm/min.
The edges of the plates should not be sharp. A solid steel rod 3/4
in or 19 mm in diameter and a length equal to at least 6 in or 150
mm is to be bolted or otherwise secured to the upper face of the
lower plates. The longitudinal axis of the plates and the rod are
to be in the same vertical plane. |
Details
